Search results for "Metal and composite structure"
showing 5 items of 5 documents
Computational Study of Failure of Hybrid Steel Trussed Concrete Beams
2017
This study investigates the failure behavior of hybrid steel trussed concrete beams (HSTCBs) under three-point bending through a series of finite-element (FE) simulations. The FE model employs well-established constitutive relations of concrete and steel with a simplified contact condition between the concrete and steel truss. The numerical model is compared with existing experimental data as well as a FE model that uses a more sophisticated concrete-steel interfacial model. The comparison shows that the present model is able to capture various failure mechanisms of the beam and its peak load capacity. The model is applied to investigate the behavior of a set of HSTCBs of different sizes, w…
Laminated Glass Members in Compression: Experiments and Modeling
2014
It is well known that structural glass members are made by assembling thin laminated panels, which can be connected with different bonding techniques; for instance, with steel devices or with structural adhesives. The latter are very commonly used because they do not reduce the transparency of the member and make it possible to avoid stress concentrations because of the presence of holes. This technique is used to make up columns in glazing structures and different applications of the technique can be found in contemporary architecture. As evidenced by the literature, one of the most important problems in such members is caused by buckling phenomena, resulting from the slenderness of the pa…
Structural Behavior of Telescopic Steel Pipe for a Full-Scale 60 kW Wind Turbine Tower
2020
A simple analytical model, including local effects due to buckling and shear to moment interaction, was developed to pre-dict the load-carrying capacity of CHS tubes under flexure and shear. A finite-element analysis with ABAQUS Code was also conducted for validation of the proposed model. By properly modeling the imperfection effects due to the ovalization of steel tube, a good correlation of the structural response and failure mode was also achieved, and a good correlation with the analytical model was also achieved. Numerical and analytical results were compared with experimental results recently obtained by the author with good agreement. Experimental tests refer to full-scale static te…
Experimental Investigation of the Shear Response of Precast Steel-Concrete Trussed Beams
2017
The results of an experimental campaign of three-point bending tests on precast composite beams, named hybrid steel-trussed concrete beams (HSTCBs), are provided. HSTCBs are typically constituted by a precast steel truss embedded in a block of concrete cast in place. Two series of specimens were manufactured, designed such that shear failure would occur, and tested under positive and negative bending moment. The experimental results obtained showed that fragile shear failure occurred in almost all cases, evidencing the crisis of the compressed concrete strut involved in the collapse mechanism. Yielding of the steel members provided ductility to the system, especially in those cases in which…
Flexural Test on a Full-Scale 60-kW Wind Turbine-Tower Telescopic Steel Pipe
2019
A full-scale static test to failure was conducted on 6-m (236.22 in.)-long steel pipes constituting a segment of a telescopic wind tower with a 60-kW wind turbine. The diameter of the circular cross section of the steel pipes was 900 mm (35.43 in.), and the nominal thickness was 10 mm (0.39 in.). The steel grade was 355 MPa (51,488 psi). The tests were conducted in a force-controlled mode in a four-point bending test with a shear-to-span ratio of 2.05. The flexural limit states developed in the form of ovalization of the cross section and of local buckling. The buckling occurred in the plastic range because of the diameter-to-thickness ratio of the section. Although local buckling caused sl…